Why oil needs to be filtered
During the operation of mechanical equipment, oil will produce a lot of impurities due to friction and other factors. If these impurities are not filtered out, it will cause long-term damage to the equipment. Usually, the hydraulic system and lubricating oil system are equipped with filter devices. If no filter is installed, an external oil purifier is required to purify the oil. The oil filtration can be connected to the hydraulic oil system or lubricating oil system, and the oil purification can be completed without affecting the operation of the system.
What oils can an oil filtration system be used for?
Hydraulic oil
In the hydraulic system, when replacing the new oil, it is best to filter the oil. You can use an oil filtration machine to filter out the tiny impurities that may exist in the new oil to reduce the pressure of the hydraulic system.
Lubricating oil
The purpose of lubricating oil is to make the transmission part of the system smoother and reduce friction as much as possible, so it is necessary to use an oil purifier to filter out the tiny impurities in the oil.
High viscosity oil
For oil with higher viscosity, ordinary oil purifier can not play the best performance, the oil purifier produced by Xxfil specially designed for processing high viscosity oil can effectively remove particulate pollution in oil with viscosity range of 160-760cSt.
Transformer oil
The oil used in transformers usually has higher performance requirements, and particles and moisture will seriously contaminate the oil. You need to use a vacuum oil filtration machine or a coalescing dewatering oil purifier to filter out contaminants from the oil.
Application of oil filtration machine
The oil filtration machine is mainly used in mining, metallurgy, petroleum, railway, machinery, chemical industry, textile, cement, power plant, instrumentation and other departments. It plays a great role in the purification and regeneration of various industrial lubricating oils that are polluted and deteriorated, prolongs the maintenance cycle and service life of equipment, and reduces production costs. It can effectively remove pollutants in oil products such as water, water-soluble acids, alkalis, mechanical impurities, etc., and improve the kinematic viscosity, flash point and emulsifying properties of oil products. Quickly restore the oil to the required performance.
What should you pay attention to when using an oil purifier
1. All parts of the oil filtration machine have been adjusted and tested before leaving the factory. When they are transported to the site of use, they must be checked whether they are in good condition.
2. The oil filtration machine is placed smoothly, the oil inlet is connected to the oil discharge port at the lower part of the oil tank, and the oil outlet is connected to the upper part of the oil tank.
3. After long-distance transportation, it is necessary to re-tighten the connection parts of various components, such as connecting flanges, filter cover plates, etc.
4. The external wiring of the control panel is shown in the electrical wiring diagram. Connect the 380V three-phase four-wire AC power from the lower left side of the electric control cabinet. The shell of the control panel should be reliably grounded, and the oil purifier should be connected to the power supply and ground wire.
5. Turn on the main power switch and check whether the power indicator is on. If it does not light up, check and troubleshoot according to the circuit diagram
